Subscibe Our Newsletter

Move your mouse over me

Follow Us
advertise with us


Foam-Cup Bell

Author:  GSLC

Materials Needed:
Foam cup,
bell on a string, or bell and string to attach bell to,

Turn the cup upside down.
Cut a small hole in the top (bottom normally) of the cup.
Thread the string attached to the bell through hole.
Remember to leave part of the string inside the cup so the bell can swing back and forth.
Tie a half knot in the string near the opening of the cup to keep the string
from sliding back into the cup, or use tape to secure it.
Decorate the cup with stickers.

References / Source:
GSLC Pow Wow 2008
Please Share!

Other Pages you May Like



Forgot Password     Signup



About | Sitemap | Advertise | Contact | Privacy Policy | Terms Of Service | Cookie Policy

Helping Scout leaders one resource at a time...

Managed by SRsquare and Generously hosted by ServerWarp

Materials found on the InsaneScouter's Website © 1998 - 2019 may be reproduced and used by all Scouting volunteers for anything consistent with Scouting and Guiding Organizations. Unless otherwise noted on the page. If you believe we are republishing your copyrighted material without permission, please Contact Us including the link/url to have it removed or your copyright information added.

Please be advised that InsaneScouter is NOT affiliated with any Scouting or Guiding Organization.

All opinions expressed on these pages are those of the original authors. All holdings are subject to this Disclaimer.